13-104344City of Federal Way
Community & Econ. Dev. Services
33325 8th Ave S
Federal way, WA 98003
Ph: (253) 835.2607 Fax: (253) 835-2609
1
Project Name: GARCIA
Project Address: 34511 15TH PL SW 0000,
Project Description: REPLAC114T iS Tt A)E VO
W 80 GAS
Number: 6664910210
OWWK
R C
G
1EMAIN
Contractor
GRIMS HEATING INC (GENERAL)
Meehanical
HEATING INC
Tils
Permit #:
13 -104344 -00 -ME
�
Inspection Request Line: (253) 835-3050
1
Project Name: GARCIA
Project Address: 34511 15TH PL SW 0000,
Project Description: REPLAC114T iS Tt A)E VO
W 80 GAS
Number: 6664910210
OWWK
R C
G
1EMAIN
Contractor
GRIMS HEATING INC (GENERAL)
34511 1 SW
HEATING INC
GRUTIU088DZ (115115)
FEDE A -7050
40ST SUITE 130
402 E MAIN ST SUITE 130
AUBURN WA 98002
AUBURN WA 98002
Is this an Online or O.T.C. application? ........... ....Yes
�® N1AIr
'
fE&Ii EXPIRES Monday,
Permit Issued on Wednesda ,
I hereby ce that the above info pf57%is correct t
the occupancy and the use will be i ��rda ,
Owner or agent:
Wh ch 3% 2014
ftb'er 2, 2013
stru the Bove described properly and
nd regu of the State of Washington
Way.
/ 2
fDate:
QTY CW
Federal Way
PERMIT #:
M TRIS CARD IS TC&MAIN ON-SITE
Construction Inspection Record
INSPECTION REQUE TS: (253) 835-3050
13 -104344 -00 -ME
Address: 34511 15TH PL SW
Project: TIMOTHY R GARCIA FEDERAL WAY, WA 98023-7050
Scheduled inspections may be failed if this card is not on-site. DO NOT LOSE THIS CARD. Inspections are listed as close to sequential order as
possible (read left to right, top to bottom). Please schedule inspections as appropriate. Work must not be covered until it is approved Check with your
inspector if you are unsure about any of the inspections or the inspection sequence. On-going inspections are logged on the back of this card
Mechanical Rough -in (4165)Gas
Piping (4125)
Final Electrical
Approved
Final - Mechanical 4065)
Approved
JE]Approved
to release test
Approved
By
Date
By
Date
By
Date
Rough Electrical
Approved
Final Electrical
Approved
Right of Way
Approved
By
Date
By
Date
By
Date
•CITY OF j Building Division
33325 Eighth Avenue South
Federal Wa Federal Way, 98003-6325
y Phone 253-835-2607 Fax
253-835-2609
CORRECTION NOTICE
ADDRESS: 21 S!}- I t l'l,'r1, `\ L S w PERMIT#:
IF YOU HAVE QUESTIONS CALL
(253) 835- d' (3
WHEN CORRECTIONS HAVE BEEN MADE, CALL (253) 835-3050 FOR RE -INSPECTION. SEE BACK OF CARD
FOR DETAILS. NOTE: ELECTRICAL CORRECTIONS ARE REQUIRED TO BE MADE WITHIN 15 DAYS.
DATE INSPECTOR
DO NOT REMOVE THIS NOTICE
Page of
11
Duct Leakage Affidavit
Permit #: LF -1 10 143
House address r lot number. / S 15 fL � S GJ
City: WO, Zip:
Cond. Floor Area (ft): ��J v v _ Source (circle one): Plans Estimated Measured
❑ Duct tightness testing is not required for this residence per exceptions listed at the end of this document
Air Handier in conditioned space? ❑ yesfno Air Handler present during tesv-tfyes ❑ no
Circle Test Method: Leakage to Outside (Eot]lLeakage
j laximum duct leakage:
Post Construction, total duct leakage: (floor area x.08) _ )2 t CFM@25 Pa
Post Construction, leakage to outdoors: (floor area x .06) = CFM@25 Pa
Rough -In, total duct leakage with air handler installed: (floor area x .06) = CFM@25 Pa
Rough -In, total duct leakage with air handler not installed: (floor area x.04) = CFM@25 Pa
Test Result: CFM@25Pa
Ring (circle one if applicable): Open 1 2 3
Duct Tester Location:'
Pressure Tap Location: f lJt
I certify that these duct leakage rates are accurate and determined using standard du t 'n protocol.
Company Name: �i I VI Technician: [1�i O
_J�Technician Signature:-2Zk=::I--Date: 0_343 Phone Number.
Washington State Energy Code reference:
503.10.3 Sealing. All ducts, air handlers, filter boxes, and building cavities used as ducts shall be sealed. Joints and seams shall comply
with Section M1601.3 of the /nternadonal Residential Code or 603.9 of the Intemadonal Mechanical Code. Duct tightness testirg shall be
conducted to verify that the ducts are sealed. A signed affidavit documenting the test results shall be provided to the jurisdiction having
authority by the testing agent. When required by the building official, the test shall be conducted in the presence of department staff.
Exceptions: 1. Duct tightness test is not required if the air handler and all ducts are located within conditioned space.
2. Duct testing is not required if the furnace is a nondirect vent type combustion appliance installed in an unconditioned space.
A maximum of six feet of connected ductwork in the unconditioned space is allowed. All additional supply and return ducts
shall be within the conditioned space. Ducts outside the conditioned space shall be sealed with a mastic type duct sealant and
insulated on the exterior with R-6 insulation for above grade ducts and R-5 water resistant insulation when within a slab or
earth.